***PLEASE NOTE: Motovation must insist that all protection parts and accessories are professionally installed to ensure proper fitment and maximum protection. These instructions are for reference only, and do not reference a specific bike model. Your installation procedure may vary.***

Motovation Swingarm Spool Sliders

These spools have been designed to offer additional protection to your swingarm, calipers and rotors in the unfortunate event of a lowside or tip over, while offering the ability to use standard spool style stands. Riders around the world have tested our products on the street and track with outstanding results.

Typically a Motovation spool slider kit will include: (some models may vary slightly)

(2) Spool Slider Pucks

(2) Stainless Steel socket head bolts

(2) Small Bolt Head Washers

(2) Large Backing Washers

(2) Spacers - for swingarms that required the spool to be spaced off the swingarm




Slide the small bolt head washer onto the bolt.

Install one of the slider pucks onto the bolt.

Install the large backing washer to the backside of the spool puck.

Install the spacer onto the bolt IF YOUR SWINGRARM REQUIRES IT. Some bikes dont require the added spacing. If the puck has enough room to sit flush against the swingarm mount, then the spacers are not required.

Blue Loctite is highly recommended.



Please double check your install and feel free to CONTACT US with any questions. Motovation is not responsible for any damage during installation and recommends professional installation for all parts and accessories.



Motorcycles can be dangerous. Motovation has no control over the usage of any part and expects their customers to exercise good judgment as to the proper selection, installation, use and maintenance of any part. Motovation assumes no responsibility for damage or injury of any kind because of the misuse or improper installation or application of any part in any way by any person. MotovationUSA shall not be liable for any indirect or consequential damages whatsoever.