Motovation FFSY04 Fork Slider Installation Instructions

***PLEASE NOTE: Motovation must insist that all protection parts and accessories are professionally installed to ensure proper fitment and maximum protection.***

These sliders have been designed to offer unsurpassed protection to your forks, wheels, calipers and rotors in the unfortunate event of a lowside or tip over. Riders around the world have tested our products on the street and track with outstanding results.


(2) Axle Slider Pucks

(2) Stainless Steel socket head bolts

(1) Aluminum expander

(1) Threaded insert adapter



Remove the Yamaha fork axle retaining nut.

Install the supplied SS adapter nut onto the factory axle.

Tighten the SS Adapter onto the factory axle using a 24mm socket wrench and torque to NO MORE than 34 ft/lbs. Blue Loctite is highly recommended.

Attach the slider puck to the SS adapter with the SS screw. Blue Loctite is highly recommended.

Attach the other slider to the other side by inserting it into the recess and tighten the screw till the insert expands into the recess and starts to fit snugly.

Make sure that the slider fits snugly into the front axle.

Tighten screws till both sliders are snug in the axle and do not rotate easily. DO NOT OVER TIGHTEN.


Please double check your install and feel free to CONTACT US with any questions. Motovation is not responsible for any damage during installation and recommends professional installation for all parts and accessories.


Motorcycles can be dangerous. Motovation has no control over the usage of any part and expects their customers to exercise good judgment as to the proper selection, installation, use and maintenance of any part. Motovation assumes no responsibility for damage or injury of any kind because of the misuse or improper installation or application of any part in any way by any person. MotovationUSA shall not be liable for any indirect or consequential damages whatsoever.