Location & Currency
These front fork sliders help to protect your motorcycle during a slide or drop.
Comes with everything needed to install. A relatively easy install with minimal tools. Motovation sliders are the best way to protect your bike, and are the same quality that riders and racers have come to expect from over a decade of research and development from the team at Motovation. Designed for both street and track use.
Motovation Part # FFSH05
Fits: Honda CBR600RR (2004-2006)
Note: Images are for reference and may vary to fit your exact model
Motovation Fork Slider Installation Guide - Frame Sliders and Accessories
Motovation Front Axle Mounted Fork Sliders Install Instructions Congratulations! You have just purchased the world’s finest fork sliders for the modern sportbike. These sliders have been designed to offer unsurpassed protection to your forks, calipers and rotors in the unfortunate event of a lowside or tip over. Motovation fork sliders are designed and manufactured by a company that only makes frame sliders and sportbike protection accessories. Each and every model is tested for drop and slide protection. They are tough but not brittle and can also absorb a huge impact. Sportsriders around the world who have tested various models of our products on the track have all given their thumbs up after experiencing first hand, the benefits of Motovation Fork Sliders.
Please read all instructions before beginning work! These fork sliders are designed to fit specific left and right sides of your front axle so every part is unique. If there is a longer screw it will always be used for the longer slider and the slider with the larger diameter insert will always fit the side of your front axle with the larger diameter clearance hole. It will be very obvious if you have installed them in reverse as they will most likely not fit.
Included in this kit: (2)slider pucks (1)anodized aluminum rod, internally threaded (2) stainless steel M8 socket screws
Tools Required:8mm allen key x 2
Install the first slider onto the threaded rod with the correct screw.
Insert the rod with the slider into the front axle of your bike.
Make sure that the slider fits snugly into the front axle. If it does not you have inserted it from the wrong side.
Install the second slider with the remaining screw and tighten till both sliders are snug in the axle and do not rotate easily.
DO NOT OVERTIGHTEN. We recommend some non-permanent Loctite on all screw threads whenever possible. This will prevent the untimely loss of your sliders from improper tightening torque.
WARRANTY AND LIABILITY LIMITATIONS Except as may be expressly set forth in the product invoice, MotovationUSA makes no representations or warranties as to any of the products distributed by us, expressed or implied, including without limitation any warranties of merchantability or fitness for a particular purpose. Motorcycles can be dangerous. MotovationUSA has no control over the usage of any part and expects their customers to exercise good judgment as to the proper selection, installation, use and maintenance of any part. MotovationUSA assumes no responsibility for damage or injury of any kind because of the misuse or improper application of any part in any way by any person. MotovationUSA shall not be liable for any indirect or consequential damages whatsoever. All matters shall be interpreted under Texas law. All merchandise distributed by MotovationUSA is guaranteed against defects in material and workmanship only. Final decision will be made in a just and prompt manner. Replacement will be limited to parts only and does not include labor claims of any type. If the manufacturer has a written warranty, it will be included with the item you purchased. The manufacturer shall be solely responsible for any damage to person or property arising from design and manufacture and testing of its products and we accept no liability for such damages. We shall not be liable for consequential damages.
© 2005 Motovation Accessories
© 2004 - 2019 Motovation Accessories. All rights reserved.