Motovation Kawasaki ZX6R Installation Guide - Frame Sliders and Accessories

2005 Kawasaki ZX6R 636 Ninja Frame Sliders Install Instructions

Congratulations! You have just purchased the world’s finest frame sliders for the 2005 Kawasaki ZX6R 636 Ninja. These sliders have been designed to offer unsurpassed protection to your 2005 Kawasaki ZX6R 636 Ninja in the unfortunate event of a lowside or tip over. Motovation frame sliders are designed and manufactured by a company that only makes frame sliders. Each and every model is tested for drop and slide protection. They are tough but not brittle and can also absorb a huge impact. Sportsriders around the world who have tested various models of our products on the track have all given their thumbs up after experiencing first hand, the benefits of Motovation Frame Sliders.

Please read all instructions before beginning work! These frame sliders are designed to fit specific engine mounts of your 2005 Kawasaki ZX6R 636 Ninja. This kit has separate left and right pieces (left and right while sitting on the bike). It is highly recommended that you refer to your service manual before performing this installation. If you are unsure about the tightening torque, here are some standard torque settings to serve as a guide. Some fairing modification is required on the left side.

Included in this frame sliders kit:
(1) 10mmX90mm 1.25 pitch bolt (left)
(1) 10mmX130mm 1.25 pitch bolt (right)
(2) Aluminum bushings (pressed into slider)
(2) Plastic Frame Sliders (left -longer, right-shorter)

INSTRUCTIONS:

zx6 Ninja frame sliders

Left Hand Side ( Sitting On Bike )
Remove left side fairing.
Remove( See picture ) correct engine bolt and save the nut.
Replace with the provided Left Slider ( Longer Aluminum Spacer) and 100mm bolt and re-use the stock nut.
Tighten the frame slider to the manufacturer’s recommended torque settings.
Replace the fairing and mark the edge of the fairing that needs modification. Tape fairing over with masking tape and dremel the fairing till it just clears the frame slider.
Reinstall fairing.

Right Hand Side ( Sitting On Bike )
Remove ( See picture ) correct engine bolt and save the nut.
Install the provided Right Slider ( Shorter Aluminum spacer ) and 130mm bolt and re-use nut.
Tighten the frame slider to the manufacturer’s recommended torque settings.

DO NOT OVERTIGHTEN.

Thank-you for purchasing Motovation products. Please ride safe and always wear protective clothing.

WARRANTY AND LIABILITY LIMITATIONS
Except as may be expressly set forth in the product invoice, MotovationUSA makes no representations or warranties as to any of the products distributed by us, expressed or implied, including without limitation any warranties of merchantability or fitness for a particular purpose. Motorcycles can be dangerous. MotovationUSA has no control over the usage of any part and expects their customers to exercise good judgment as to the proper selection, installation, use and maintenance of any part. MotovationUSA assumes no responsibility for damage or injury of any kind because of the misuse or improper application of any part in any way by any person. MotovationUSA shall not be liable for any indirect or consequential damages whatsoever. All matters shall be interpreted under Texas law. All merchandise distributed by MotovationUSA is guaranteed against defects in material and workmanship only. Final decision will be made in a just and prompt manner. Replacement will be limited to parts only and does not include labor claims of any type. If the manufacturer has a written warranty, it will be included with the item you purchased. The manufacturer shall be solely responsible for any damage to person or property arising from design and manufacture and testing of its products and we accept no liability for such damages. We shall not be liable for consequential damages.