Suzuki Vstrom 650/1000 SV650/1000.Frame Slider Install

2003-4 Vstrom 650/1000 SV650/1000 Frame Sliders Install Instructions

Congratulations! You have just purchased the world’s finest frame sliders for the Vstrom 650/1000 SV650/1000. These sliders have been designed to offer unsurpassed protection to your Vstrom 650/1000 SV650/1000 in the unfortunate event of a lowside or tip over. Motovation frame sliders are designed and manufactured by a company that only makes frame sliders. Each and every model is tested for drop and slide protection. They are tough but not brittle and can also absorb a huge impact. Sportsriders around the world who have tested various models of our products on the track have all given their thumbs up after experiencing first hand, the benefits of Motovation Frame Sliders.

Please read all instructions before beginning work! These frame sliders are designed to fit specific engine mounts of your Vstrom 650/1000 SV650/1000. This kit has separate left and right pieces (left and right while sitting on the bike). It is highly recommended that you refer to your service manual before performing this installation. If you are unsure about the tightening torque, check your motorcycle's manual or www.motovationusa.com/torque.html for a quick reference guide.

vstrom sv frame sliders

Included in this kit:
(1) 12mmX420mm bolt, locknuts attached
(2) Aluminum bushings (pressed into slider)
(2) Plastic Frame Sliders
- Left (larger diameter insert)
- Right (smaller diameter insert)

INSTRUCTIONS:

vstrom sv frame sliders

The use of an impact wrench and a quality 6-point socket is recommended for the removal of the stock nut.

1. Remove the right-side lower-center engine mount nut (see pic).
2. Remove the through bolt, out the left hand side.
3. From the left side, install the left slider with the larger diameter insert into the frame. Insert the bolt provided with the nut installed through the slider and into the frame. Be sure to align the spacer on the right side while feeding the bolt through the engine mount.

4. From the right side install the right slider with the smaller diameter insert onto the bolt provided and thread the supplied locknut.
5. Tighten and torque the nut (55-60 ft. lbs. is recommended).

DO NOT OVERTIGHTEN.

Thank-you for purchasing Motovation products. Please ride safe and always wear protective clothing.

WARRANTY AND LIABILITY LIMITATIONS
Except as may be expressly set forth in the product invoice, MotovationUSA makes no representations or warranties as to any of the products distributed by us, expressed or implied, including without limitation any warranties of merchantability or fitness for a particular purpose. Motorcycles can be dangerous. MotovationUSA has no control over the usage of any part and expects their customers to exercise good judgment as to the proper selection, installation, use and maintenance of any part. MotovationUSA assumes no responsibility for damage or injury of any kind because of the misuse or improper application of any part in any way by any person. MotovationUSA shall not be liable for any indirect or consequential damages whatsoever. All matters shall be interpreted under Texas law. All merchandise distributed by MotovationUSA is guaranteed against defects in material and workmanship only. Final decision will be made in a just and prompt manner. Replacement will be limited to parts only and does not include labor claims of any type. If the manufacturer has a written warranty, it will be included with the item you purchased. The manufacturer shall be solely responsible for any damage to person or property arising from design and manufacture and testing of its products and we accept no liability for such damages. We shall not be liable for consequential damages.