2002-2005 Honda RC51 / SP2 Race Frame Sliders Install Instructions

Congratulations! You have just purchased the world’s finest frame sliders for the 2002-2005 Honda RC51 / SP2. These sliders have been designed to offer unsurpassed protection to your 2002-2005 Honda RC51 / SP2 in the unfortunate event of a lowside or tip over. Motovation frame sliders are designed and manufactured by a company that only makes frame sliders. Each and every model is tested for drop and slide protection. They are tough but not brittle and can also absorb a huge impact. Sportsriders around the world who have tested various models of our products on the track have all given their thumbs up after experiencing first hand, the benefits of Motovation Frame Sliders.

Please read all instructions before beginning work! These frame sliders are designed to fit specific engine mounts of your 2002-2005 Honda RC51 / SP2. This kit has separate left and right pieces (left and right while sitting on the bike). It is highly recommended that you refer to your service manual before performing this installation.

Instructions:
Remove fairings.
Remove the right-side engine mount nut.(just below the radiator)
Remove the through bolt, out the left-hand side.
From the left side, install the longer piece slider.
The spacer should fit into the engine mount completely, allowing the frame slider to sit flush with the mount.
Install the right side slider, using the supplied lock nut.
Once you are confident that the sliders fit correctly, remove the nuts and the sliders and follow the fairing modification instructions.

Fairing modification instructions:
Install the slider bolt without the slider. Re-install the fairing to mark the inside of the fairing for the pilot hole. We sometimes coat the head of the bolt with a non permanent marker or place some putty on the inside of the fairing so the the screw will make a mark or an indentation. Once the center of the bolt location on the fairing is determined, it is suggested that you drill a small pilot hole to locate the engine mount point on the fairing. Once you have found the center, use a hole saw and cut a hole approximately 48mm in diameter. Edges can then be filed larger for perfect fit, or inaccuracies in drilling. We have found that placing masking tape on the area helps protect from scratches, cracks, etc. and a dremel is great for adjusting the hole size. Re-install the sliders with the supplied locknuts and tighten to factory specs. DO NOT OVERTIGHTEN.

Thank-you for purchasing Motovation products.  Please ride safe and always wear protective clothing.