2004-5 Yamaha FJR1300 Street (no cut) Frame Sliders Install Instructions
Congratulations! You have just purchased the world’s finest frame sliders for the 2004-5 Yamaha FJR1300. These sliders have been designed to offer unsurpassed protection for your Yamaha FJR1300 in the unfortunate event of a lowside or tip over. Motovation frame sliders are designed and manufactured by a company that only makes frame sliders. Each and every model is tested for drop and slide protection. They are tough but not brittle and can also absorb a huge impact. Sportsriders around the world who have tested various models of our products on the track have all given their thumbs up after experiencing first hand, the benefits of Motovation Frame Sliders.
Please read all instructions before beginning work! These frame sliders are designed to fit specific engine mounts of your Yamaha FJR1300. This kit has separate left and right pieces (left and right while sitting on the bike). It is highly recommended that you refer to your service manual before performing this installation. If you are unsure about the tightening torque, check your motorcycle's manual or www.motovationusa.com/torque.html for a quick reference guide
| Included in
this kit: 2 x Left/ Right side frame sliders 2 x thicker aluminum spacers ( Left ) 2 x thinner aluminum spacers ( Right ) 2 x Left/ Right Hi Grade aluminum brackets 3 x m12 x 80mm socket head cap screws 1 x m12 x 70mm socket head cap screw 2 x m10 x 50mm socket head capscrews for sliders. |
Tools Required: Torque Wrench 10mm allen key for Torque Wrench 8mm allen key Phillips screw driver |
INSTRUCTIONS: Attempt this install one side at a time.
 1) Remove both side fairings. Remove left side original bolts. Leave original washers in place. Install the supplied spacers as shown: Left Side Spacers x 2 pcs (thicker ones). Right Side Spacers x 2 pcs (thinner ones). |
|
|
  4) Re-install the left and right fairings to their original locations. This will leave only the mounting locations for the frame sliders visible on both sides.   5) Install the supplied frame sliders with the remaining bolts and tighten. Do not overtighten. |
Thank-you
for purchasing Motovation products. Please ride safe and always
wear a helmet and protective clothing.
WARRANTY AND LIABILITY LIMITATIONS
Except as may be expressly set forth in the product invoice, MotovationUSA
makes no representations or warranties as to any of the products
distributed by us, expressed or implied, including without limitation
any warranties of merchantability or fitness for a particular purpose.
Motorcycles can be dangerous. MotovationUSA has no control over the
usage of any part and expects their customers to exercise good judgment
as to the proper selection, installation, use and maintenance of
any part. MotovationUSA assumes no responsibility for damage or injury
of any kind because of the misuse or improper application of any
part in any way by any person. MotovationUSA shall not be liable
for any indirect or consequential damages whatsoever. All matters
shall be interpreted under Texas law. All merchandise distributed
by MotovationUSA is guaranteed against defects in material and workmanship
only. Final decision will be made in a just and prompt manner. Replacement
will be limited to parts only and does not include labor claims of
any type. If the manufacturer has a written warranty, it will be
included with the item you purchased. The manufacturer shall be solely
responsible for any damage to person or property arising from design
and manufacture and testing of its products and we accept no liability
for such damages. We shall not be liable for consequential damages.
© 2005 Motovation Accessories