Motovation Honda 996 Superhawk frame sliders Installation Guide

2004 onwards Honda 996 Superhawk Frame Slider Installation Instructions

Congratulations! You have just purchased the world’s finest frame sliders for the Honda 996 Superhawk. These sliders have been designed to offer unsurpassed protection for your Honda 996 Superhawk in the unfortunate event of a lowside or tip over. Motovation frame sliders are designed and manufactured by a company that only makes frame sliders. Each and every model is tested for drop and slide protection. They are tough but not brittle and can also absorb a huge impact. Sportsriders around the world who have tested various models of our products on the track have all given their thumbs up after experiencing first hand, the benefits of Motovation Frame Sliders.

Please read all instructions before beginning work! These frame sliders are designed to fit specific engine mounts of your Honda 996 Superhawk. This kit has separate left and right pieces (left and right while sitting on the bike). It is highly recommended that you refer to your service manual before performing this installation. If you are unsure about the tightening torque, check your motorcycle's manual or www.motovationusa.com/torque.html for a quick reference guide

Included in this kit:
2 Sliders with aluminum inserts(smaller diameter insert-right)
1 M10 x 130 1.25 bolt (left side)
1 M10 x 110 1.25 bolt (right side)

Tools Required:
Torque Wrench
10mm socket

INSTRUCTIONS:
-Remove your bike's fairing.
-Remove the frame bolts as indicated by the red arrows in the pics.
-Install the sliders using the replacement bolts and washers as supplied with your slider kit.
We recommend that you observe your manufacturer's torque specifications and some Loctite anti-vibration compound when installing the replacement bolts supplied with your sliders.
-We recommend using a Dremel or similar type tool on your fairing to ensure proper fitment of the slider. Start with a small cut on the fairing and then expand the area till it just clears the installed slider. Repeat the process for the other side of the bike.
-Re-install your fairing.

Thank-you for purchasing Motovation products. Please ride safe and always wear protective clothing.

WARRANTY AND LIABILITY LIMITATIONS
Except as may be expressly set forth in the product invoice, MotovationUSA makes no representations or warranties as to any of the products distributed by us, expressed or implied, including without limitation any warranties of merchantability or fitness for a particular purpose. Motorcycles can be dangerous. MotovationUSA has no control over the usage of any part and expects their customers to exercise good judgment as to the proper selection, installation, use and maintenance of any part. MotovationUSA assumes no responsibility for damage or injury of any kind because of the misuse or improper application of any part in any way by any person. MotovationUSA shall not be liable for any indirect or consequential damages whatsoever. All matters shall be interpreted under Texas law. All merchandise distributed by MotovationUSA is guaranteed against defects in material and workmanship only. Final decision will be made in a just and prompt manner. Replacement will be limited to parts only and does not include labor claims of any type. If the manufacturer has a written warranty, it will be included with the item you purchased. The manufacturer shall be solely responsible for any damage to person or property arising from design and manufacture and testing of its products and we accept no liability for such damages. We shall not be liable for consequential damages.