Congratulations!
You have just purchased the world’s finest frame sliders
for the 2005 Kawasaki ZX6R 636 Ninja. These sliders have been designed
to offer unsurpassed protection to your 2005 Kawasaki ZX6R 636
Ninja in the unfortunate event of a lowside or tip over. Motovation
frame sliders are designed and manufactured by a company that only
makes frame sliders. Each and every model is tested for drop and
slide protection. They are tough but not brittle and can also absorb
a huge impact. Sportsriders around the world who have tested various
models of our products on the track have all given their thumbs
up after experiencing first hand, the benefits of Motovation Frame
Sliders.
Please
read all instructions before beginning work! These frame
sliders are designed to fit specific engine mounts of your
Suzuki 2005 Kawasaki ZX6R 636 Ninja. This kit has separate
left and right pieces (left and right while sitting on the
bike). It is highly recommended that you refer to your service
manual before performing this installation. If you are unsure
about the tightening torque, here are some standard
torque settings to serve as a guide. Some fairing modification
is required on the left side.
Included
in this kit:
(1) 10mmX90mm 1.25 pitch bolt (left)
(1) 10mmX130mm 1.25 pitch bolt (right)
(2) Aluminum bushings (pressed into slider)
(2) Plastic Frame Sliders (left -longer, right-shorter)
INSTRUCTIONS:
Left
Hand Side ( Sitting On Bike )
Remove left side fairing.
Remove(
See picture ) correct engine bolt and save the nut.
Replace with the provided Left Slider ( Longer Aluminum Spacer) and 90mm
bolt and re-use the stock nut.
Tighten the frame slider to the manufacturer’s recommended torque
settings.
Replace
the fairing and mark the edge of the fairing that needs
modification. Tape fairing over with masking tape and
dremel the fairing till it just clears the frame slider.
Reinstall fairing.
Right
Hand Side ( Sitting On Bike )
Remove ( See picture ) correct engine bolt and save the nut.
Install the provided Right Slider ( Shorter Aluminum spacer ) and 130mm
bolt and re-use nut.
Tighten the frame slider to the manufacturer’s recommended torque
settings.
Log
In 
