Congratulations! You have just purchased the world’s finest frame sliders
for the Kawasaki ZX10R. These sliders have been designed to offer unsurpassed
protection to your Kawasaki ZX10R in the unfortunate event of a lowside
or tip over. Motovation frame sliders are designed and manufactured by a company
that only makes frame sliders. Each and every model is tested for drop and
slide protection. They are tough but not brittle and can also absorb a huge
impact. Sportsriders around the world who have tested various models of our
products on the track have all given their thumbs up after experiencing first
hand, the benefits of Motovation Frame Sliders.
Please read all instructions
before beginning work! These frame sliders are designed to
fit specific engine mounts of your Kawasaki ZX10R. This
kit has separate left and right pieces (left and right while
sitting on the bike). It is highly recommended that you refer
to your service manual before performing this installation.
If you are unsure about the tightening torque, here are some standard
torque settings to serve as a guide. Fairing modification
is also required. Please read the section about fairing modifcation
before beginning.
Included
in this kit:
(1) longer slider (left side).
(1) shorter slider (right side).
(1) M10x140 (left)
(1) M10x130 (right)
Tools Required:
Torque Wrench
10mm allen key for Torque Wrench
.25mm hole cutter/saw
INSTRUCTIONS:
Important! Remove
bolts one side at a time. Please read section about fairing
modification first before installing sliders.
Left Hand Side (Sitting
On Bike)
Remove left side fairing panel.
Remove (See picture)
correct engine bolt.
Perform fairng mod (see bottom of page), replace the
fairing and Insert the Left Slider (longer
slider) aluminum bush through
the fairing and install with the provided and
140mm bolt.
Tighten to the manufacturer’s recommended torque settings.
Right Hand Side (Sitting
On Bike)
Remove right side fairing panel
Remove (See picture) correct engine bolt.
Perform fairng mod (see bottom of page), replace the
fairing and Insert the Right Slider (shorter
slider) aluminum bush through
the fairing and install with the provided and
130mm bolt.
Tighten to the manufacturer’s recommended torque settings.
Fairing modification
instructions:
Install the slider bolts without the slider. Engage only a few threads
and re-install the fairing to mark the inside of the fairing for the pilot
hole. We sometimes coat the head of the socket screw with a non permanent
marker or place some putty on the inside of the fairing so the the screw will
make a mark or an indentation. Once the center of the bolt location on
the fairing is determined, it is suggested that you drill a small pilot hole
to locate the engine mount. Once you have found the center, use a hole saw
and cut a hole approximately 25mm in diameter. Edges can then be filed larger
for perfect fit, or inaccuracies in drilling. We have found that placing masking
tape on the area helps protect from scratches, cracks, etc. and a Dremel tool
is great for adjust the hole size.
Replace the fairing panels, install the
sliders in place and torque to manufacturer's specs.
Thank-you for purchasing
Motovation products. Please ride safe and always wear
protective clothing.
Log
In 
