Congratulations! You have just purchased the world’s finest frame sliders
for the Kawasaki Z1000 / 750. These sliders have been designed to offer unsurpassed
protection to your Kawasaki Z1000 / 750 in the unfortunate event of a lowside
or tip over. Motovation frame sliders are designed and manufactured by a company
that only makes frame sliders. Each and every model is tested for drop and
slide protection. They are tough but not brittle and can also absorb a huge
impact. Sportsriders around the world who have tested various models of our
products on the track have all given their thumbs up after experiencing first
hand, the benefits of Motovation Frame Sliders.
Please read all instructions
before beginning work! These frame sliders are designed to
fit specific engine mounts of your Kawasaki Z1000 / 750. This
kit has separate left and right pieces (left and right while
sitting on the bike). It is highly recommended that you refer
to your service manual before performing this installation.
If you are unsure about the tightening torque, here are some standard
torque settings to serve as a guide.
Included
in this kit:
(1) longer slider with the short alum spacer (left side).
(1) shorter slider with the longer alum spacer (right side).
(1) M10x160 1.5 w/S.S nut
(1) M10x190 1.5 w/S.S nut
INSTRUCTIONS:
Important! Remove
bolts one side at a time. Perform this installation on
a cool engine.
Left Hand Side (Sitting
On Bike)
Remove (See picture) correct engine bolt.
Replace with the provided Left Slider (longer slider with shorter Aluminum
Spacer) and 160mm bolt and secure with supplied stainless steel locknut
and washer.
Tighten to the manufacturer’s recommended torque settings.
Right Hand Side (Sitting
On Bike)
Remove (See picture) correct engine bolt.
Install the provided Right Slider (shorter slider with longer aluminum
spacer) and 190mm bolt and secure with supplied stainless steel locknut
and washer.
Tighten to the manufacturer’s recommended torque settings.
Log
In 
