Congratulations!
You have just purchased the world’s finest frame sliders
for the 2004-5 Yamaha FZ600. These sliders have been
designed to offer unsurpassed protection to your 2004-5 Yamaha
FZ600 in the unfortunate event of a lowside or tip over. Motovation
frame sliders are designed and manufactured by a company
that only makes frame sliders. Each and every model is tested
for drop and slide protection. They are tough but not brittle
and can also absorb a huge impact. Sportsriders around the world
who have tested various models of our products on the track have
all given their thumbs up after experiencing first hand, the
benefits of Motovation Frame Sliders.
Please
read all instructions before beginning work! These frame
sliders are designed to fit specific engine mounts of your
2004-5 Yamaha FZ600. It is highly recommended that you refer
to your service manual before performing this installation.
If you are unsure
about the tightening torque, here are some standard
torque settings to
serve as a guide.
Instructions:
1. Remove the left-side engine mount bolt as seen in left picture.
2. Install the new slider using the new bolt and washer with
the washer under
the bolt head
3. Tighten the engine mount bolt to the factory specifications
- DO NOT OVERTIGHTEN
4. Remove the right side engine mount bolt. (same place as the
other side).
5. Install the other slider using the new bolt and washer (supplied
in this kit) with the
washer under the bolt head.
6. Tighten the engine mount bolt to the factory specifications
- DO NOT OVERTIGHTEN.
Included in this kit:
(2) 10 x 100mm bolts
(2) Aluminum bushings (pressed into plastic)
(2) Plastic Frame Sliders
(2) Flat Washers
Log
In 
