Congratulations!
You have just purchased the world’s finest frame sliders
for the 2004-5 Yamaha FZ1. These sliders have been
designed to offer unsurpassed protection to your 2004-5 Yamaha
FZ1000 in the unfortunate event of a lowside or tip over. Motovation
frame sliders are designed and manufactured by a company
that only makes frame sliders. Each and every model is tested
for drop and slide protection. They are tough but not brittle
and can also absorb a huge impact. Sportsriders around the world
who have tested various models of our products on the track have
all given their thumbs up after experiencing first hand, the
benefits of Motovation Frame Sliders.
Please
read all instructions before beginning work! These frame
sliders are designed to fit specific engine mounts of your
2004-5 Yamaha FZ1. It is highly recommended that you
refer to your service manual before performing this installation.
If you are unsure
about the tightening torque, here are some standard
torque settings to
serve as a guide.
Instructions:
1. Remove the left-side engine mount bolt as seen in the first
picture.
2. Install the longer slider using the new bolt and washer with
one washer under
the bolt head.
3. Tighten the engine mount bolt to the supplied locknut
- DO NOT OVERTIGHTEN
4. Remove the right side engine mount bolt. (same place as the
other side).
5. Install the other slider using the new bolt, nut and washers
(supplied in this kit) with one
washer under the bolt head.
6. Tighten the engine mount bolt to the factory specifications
- DO NOT OVERTIGHTEN.
Included in this kit:
(2) 10 x 140mm 1.5 bolts
(2) Stainless steel lock nuts
(2) Aluminum bushings (pressed
into plastic)
(2) Plastic Frame Sliders (left-longer)
(4) Flat Washers
Log
In 
