Congratulations! You have just purchased the world’s finest frame sliders
for the 2004 Yamaha R1. These sliders have been designed to offer unsurpassed
protection to your Yamaha YZF1000 R1 in the unfortunate event of a lowside
or tip over. Motovation frame sliders are designed and manufactured by a company
that only makes frame sliders. Each and every model is tested for drop and
slide protection. They are tough but not brittle and can also absorb a huge
impact. Sportsriders around the world who have tested various models of our
products on the track have all given their thumbs up after experiencing first
hand, the benefits of Motovation Frame Sliders.
Please read all instructions
before beginning work! These frame sliders are designed to
fit specific engine mounts of your Yamaha R1. This kit has
separate left and right pieces (left and right while sitting
on the bike). It is highly recommended that you refer to your
service manual before performing this installation. If you
are unsure about the tightening torque, here are some standard
torque settings to serve as a guide.
Included in this kit:
(1) Left side Frame slider- Longer Aluminum Insert
(1) Right side Frame slider- Shorter Aluminum Insert
(2) Heat treated steel bolts -120mm
Tools Required:
Torque Wrench
8 mm Allen key for torque wrench
12mm Allen key
INSTRUCTIONS:
Left Hand Side ( Sitting On Bike )
Remove ( See picture ) correct engine bolt.
Replace the provide Left Side ( Longer Aluminum Step ) and 120mm bolt.
Tighten the frame slider to the manufacturer’s recommended torque settings.
Right Hand Side ( Sitting On Bike )
Remove ( See picture ) correct engine bolt.
Replace the provide Right Side ( Shorter Aluminum Step ) and 120mm bolt.
Tighten the frame slider to the manufacturer’s recommended torque settings.
Log
In 
