Congratulations!
You have just purchased the world’s finest frame sliders for
the Suzuki GSXR. These sliders have been designed to offer unsurpassed
protection to
your
Suzuki GSXR in the unfortunate event of a lowside or tip over. Motovation
frame sliders are designed and manufactured by a company that only
makes frame sliders. Each and every model is tested for drop and slide
protection. They are tough but not brittle and can also absorb a huge
impact. Sportsriders around the world who have tested various
models of our products on the track have all given their thumbs up
after experiencing first hand, the benefits of Motovation Frame Sliders.
Please
read all instructions before beginning work! These frame sliders are
designed to fit specific engine mounts of your Suzuki GSXR. This kit
has separate left and right pieces (left and right while sitting on
the bike). It is highly recommended that you refer to your service
manual before performing this installation. If you are unsure about
the tightening torque, here are some standard
torque settings to serve as a guide.
Included in this
kit:
(2) Heat treated socket head bolts M10 x 90mm
(2) Washers (used on the both sides, under the bolt head)
(2) Aluminum bushings (pressed into plastic)
(2) Plastic Frame Sliders • Left (longer piece) • Right (shorter
piece)
Instructions:
1. Remove the left-side engine mount bolt.
2. Install the slider using the new 10 x 90mm bolt and washer. Fairing modification
is required for this side*. The only
exception is for 2003 and newer GSXR1000.
3. Tighten the engine mount bolt to the factory specifications -
DO NOT OVERTIGHTEN. Loctite is recommended.
4. Loosen the pinch bolt on the right side.
5. Remove the right side engine mount bolt.
6. Install the shorter slider using the new 10 x 90mm bolt supplied in this
kit and the washer. No fairing modification
should be necessary on this side.
7. Tighten the engine mount bolt to the factory specifications -
DO NOT OVERTIGHTEN. Loctite is recommended.
8. Tighten the pinch bolt to the factory specifications.
* FAIRING MODIFICATIONS If you have the race kit, it is suggested
that you drill a small pilot hole to locate the engine mount.
Once you have found the center, use a hole saw and cut a hole approximately
1
7/8” in
diameter. Edges can be filed for perfect fit, or inaccuracies
in drilling. We have found that placing masking tape on the area
helps
protect from
scratches, cracks, etc.
Thank-you
for purchasing Motovation products. Please ride safe and always
wear protective clothing.
Log
In 
